online imalat pazaryeri
en uygun imalatçıyı kolay ve hızlı bulun
         
 Talepler > | Son talepler | FSN (Fason) | KLP (Kalıp) |
Talep detayı (talep sahibi ile irtibata geçmek için imalatçı firma olarak üyelik gereklidir):
09-06-2008
354
KLP
İran

Paslanmaz çelik evye kalıpları tasarım ve imalatı?..

We are going to run a stainless steel kitchen sink line in east of Iran. Regarding to this fact we want you to make demanding moulds for us.

For reducing the price, in the first stage of our project we want to use interchangeable moulds for deep drawing, embossing and punching parts, therefore we can reduce number of moulds.

We hope that after introducing our first product's range to the market reduce our moulds number and variety for reaching the higher rate.

We also make some changes in drain board part so we can use it in future's models just with changing the embossing (that insert in the mould).

Regarding to above facts, our demanding moulds for manufacturing lay-on (not welded) sinks are as follow:

1. Deep draw mould for double bowl sinks Die No: D200
2. Deep draw mould for single bowl sinks Die No: D100
3. Punching mould for strainer Die No: P100
4. Trimming and embossing mould 120*60 cm (one mould for both right and left bowl)
5. Trimming and embossing mould 120*50 cm (one mould for both right and left bowl)
6. Trimming and embossing mould 100*60 cm (one mould for both right and left bowl)
7. Trimming and embossing mould 100*50 cm (one mould for both right and left bowl)
8. Trimming and embossing mould 100*50 cm (one mould for center bowl)
9. Trimming and embossing mould 100*60 cm (one mould for center bowl)
10. Trimming and embossing mould 80*50 cm (one mould for both right and left bowl)
11. Trimming and embossing mould 50*50 cm

Note that, outside edges of lay-on sinks will produce by press break machine and for producing right or left sinks we can use press break to make an upper side edge to specify left or right direction (the upper side edge will stay toward wall).

Totally we want you to make us one deep draw mould for single bowl sinks and one deep draw mould for double bowls sinks and one interchangeable punch mould for both single and double bowl sinks and seven trimming and embossing mould.

Thank you in advance, we are looking for your good co-operation.

Waiting for your prompt reply.

For detailed info and drawings:
http://www.......zip (1,23MB) (Üyelik gereklidir)


100-50-SIN-L5

100-50-SIN-R5

100-60-SIN-M5

100-60-SIN-L5

100-60-SIN-R5

120-50-DUB-L5

120-50-DUB-R5

120-60-DUB-L5

120-60-DUB-R5
         
e-imalat.com > online imalat pazaryeri